A chiller is a refrigerating machine used in central air conditioning systems; installation used in central cooling systems of various industrial equipment.

Minimum installation dimensions, a DAIKIN scroll compressor, a special design of the compressor and heat exchangers to optimize operation on the ozone-friendly refrigerant R407C and low noise levels - all this is a high-quality series of chiller systems from Daikin.

Peculiarities

· Electronic control panel

High energy efficiency (EER, COP)

Full factory refrigerant and oil charge

Evaporator - compact plate heat exchanger

Input/Output Pins:

· Input signals

· on/off

· pump/flow switch

· Output signals

· compressor operation

· emergency signal

· pump relay contacts

· Easy installation and ease of maintenance

Compatible with DAIKIN hydraulic module

Possibility of connecting the air outlet pipe to the air duct

High static pressure at the fan outlet - up to 15 mm water column

· Fan pressure regulator

Protection against incorrect phase connection

The chiller cools or heats the coolant (antifreeze, water) and supplies it through a piping system to fan coil units (or other heat exchangers).

Industrial coolers (chillers) allow you to maintain constant temperature parameters of production equipment and premises.

Chillers are used in various combinations, in conjunction with fan coils and/or air handling units, including for industrial needs, for cooling water for technological purposes. Today, the use of chiller-fan coil systems is common.

Dozens of fan coil units can be connected to one chiller. In this case, you can set not only the general thermal regime of the entire system, but also regulate the operating mode of each fan coil from the remote control, while maintaining the required temperature in each room. The distance between the chiller and fan coils is not limited. For the installation of this system, conventional water and gas pipes with thermal insulation are used. If several chillers are installed at one site, they can be connected into one system using automation and controlled from one remote control.